Avaya Scopia XT Executive - Page 43

Field Description
When connecting over SIP, this name is displayed on the monitors
participating in the videoconference (for example, John-Smith, or
9th-Floor-Room) .
Authentication Name If necessary, enter the name for authenticating the XT Series with
the SIP server. It can be the same as the User parameter.
Authentication Password If necessary, enter the password for authenticating your XT Series
with the SIP server.
Use SIP Server Enable registering the system to the SIP server by selecting Yes.
For redundant SIP deployments, you can enter information for up
to three SIP servers, as described in Deployment Guide for Avaya
Scopia
®
XT Series.
Server Address Enter the DNS name or IP address of the SIP server, used to
register the endpoint.
2. Select Done to complete the Quick Setup Wizard.1
3. To configure advanced SIP settings, such as the preferred transport protocol, see 2
Deployment Guide for Avaya Scopia
®
XT Series.3
Related links4
Configuring Basic Settings with the Quick Setup Wizard on page 355
Installing Avaya Scopia
®
XT Control to Use Keyboard and Mouse (XT6
Executive)7
About this task8
This procedure describes how to configure your XT Executive (only) to navigate its menus with a9
keyboard and mouse by installing Avaya Scopia
®
XT Control, a small standalone program for10
Windows or Mac (see
Navigating Menus with the Keyboard and Mouse on page 29).11
Note:
You cannot install the Avaya Scopia
®
XT Control installation package on a Mac that is running12
the Yosemite operating system. The Yosemite operating system does not allow you to install13
packages obtained from outside of the Apple Store. However, there is a workaround available14
to enable you to obtain and run the installation package if you have the Yosemite operating15
system (or a higher operating system, such as El Capitan or Sierra). For more information,16
see
Resolving download problems on page 124.17
The Avaya Scopia
®
XT Control utility can only be installed from the endpoint's web interface.18
Before you begin19
1. Verify your computer is running either Windows XP/Vista/7/8, or if it is a Mac, verify it is20
running OSX 10.x or higher.21
2. Connect your computer to the XT Executive (see
Connecting a Computer to the XT Series22
using the DVI port on page 72).23
3. Perform the Quick Setup wizard, which ends with the Avaya Scopia
®
XT Control24
installation, or install it at any time from the web interface.25
Applying basic settings
December 2017 Avaya Scopia
®
XT Series User Guide 43
Avaya - Proprietary. Use pursuant to the terms of your signed agreement or Avaya policy.
DRAFT—December 15, 2017—1:33 PM (UTC)