Avaya Scopia XT7100 - Page 40

Procedure
1. To call a new endpoint, access the direct call screen. From the XT Series web interface,
select Make your Call > Basic Options > Direct Call. From the endpoint's main menu,
select Call, or press
on the XT Remote Control Unit.
Figure 27: Enter a new dial string to contact an endpoint
Enter the dial string and select Call, or press ok/menu on the XT Remote Control Unit. The
dial string can be the endpoint's number, or an H.323 alias like john_smith, or a URI address
like john@company.com.
Important:
Your organization may also have implemented a dial plan, which defines various dial
prefixes to determine the characteristics of a call. For example, you may be able to dial 8
before the videoconference number for a lower bandwidth call, or 6 for an audio-only
call. For more information on the dial plan in your organization, contact your system
administrator.
2. To dial a recently contacted endpoint, access the recent calls list. From the XT Series web
interface, select Make your call > Basic Options > Recent Calls. From the endpoint's main
menu, select Call , or press on the XT Remote Control Unit.
Figure 28: List of recently dialed endpoints
Select the entry to dial, and then select Call or press ok/menu on the XT Remote Control
Unit.
3. To dial a saved contact, access the list of contacts. From the XT Series web interface, select
Make your call > Contacts. From the endpoint's main menu, select Contacts.
Starting a New Call
40 Avaya Scopia
®
XT Series User Guide April 2015
Comments? infodev@avaya.com