03/10 Rev. 5.04-04 SERVICE MANUAL Service Mechanics
64-xx – 64-xx Dispenser
66
Assembly notes
Number and kind of the cables, which are
supposed to be connected, depend on the
printer type and equipment. In the following
are listed the most important connections.
Connect the board according to the right
figure.
A Power supply 5 V
B USI or AI
C Power supply 24 V
D Dispensing edge sensor (64-xx
dispenser)
E Backing paper rewinder sensor
(64-xx dispenser)
F Feed roller sensor (64-xx dispenser)
G Material end sensor
H Label sensor (transmission)
I Label sensor (reflex)
J Fullsize label sensor (only with fullsize
option)
K Singlestart sensor (only with optional
singlestart connector)
L Cover switch
M Power supply (data cable)
N Operation panel
O Motor output stages (data cable)
P Printhead
Q Centronics interface
Lock the cables at connectors O and P
with locking clips, see Locking clips for
flat strap plugs on page 72.
Complete list of connections: see topic
section “Electronics (Gen. 3)”, chapter
„CPU board“
B
A
C
D
E
F
G
H
I
J
K
L
M
N
O
PQ
To Next Page
Loading...
