Avery Dennison AP5.6 - Ports and Connections

05/10 Version 5.05-00 USER MANUAL Commissioning and Operation
AP5.4 – AP5.6
10
Ports and connections
For instructions on how to use the network connections, see topic section “Ad-
vanced Applications”, chapter Data Transmission with Ethernet  on page 18.
[9] The rear side of the AP 5.4/5.6 with I/O board (option) installed.
A Start/stop signal input
Connections for a foot switch (signal starts printer) or stacker (signal stops
printer)
B Signal port (option)
4 inputs / 3 outputs on optionally available I/O board
CAUTION!
Using poor quality auxiliary equipment can damage the printer.
« Only connect the printer to devices that fulfil the SELV (safety extra-low
voltage) circuit requirements in accordance with EN60950.
« Only connect original accessories.
A
D
B
C
E
F
G
H
I
J