05/10 Version 5.05-00 USER MANUAL Commissioning and Operation
AP5.4 – AP5.6
25
Using SD cards
Recommended card type:
Xmore industrial 2GB (item no. A101465) [14]
[14] Recommended SD card.
Inserting the SD card:
1. Switch off the printer.
2. Insert the SD card into the card slot as shown [15].
¯ The contacts point to the front left side.
¯ Once the card is inserted two-thirds of the way [15A], a mechanical re-
sistance becomes apparent. Apply a little more force to overcome the re-
sistance, insert the card until it stops and then release it. The card springs
back a little ways towards its final resting position [15B].
[15] Insert the SD card.
CAUTION!
To prevent malfunctions, observe the following.
« Only use SD cards that have been approved by the manufacturer.
« Only insert or remove SD cards after the printer has been switched off.
« After switching off, do not remove the SD cards until the backlighting on the
screen has gone out.
A
A B
To Next Page
Loading...
