Avery Dennison AP5.6 - Main Operating Steps; Connecting the Printer

05/10 Version 5.05-00 USER MANUAL Commissioning and Operation
AP5.4 – AP5.6
16
Main operating steps
Connecting the printer
[12] Rear side of AP 5.6.
1. Make sure that the printer is switched off (mains switch [12C] at “0” posi-
tion).
2. Connect the mains cable [12A] to the mains connector at the printer.
3. Connect the mains cable into a mains socket.
4. Connect the printer and computer or printer and network using suitable
data cable (example: USB cable to USB (device) port [12B] of printer and
to USB port of host computers).
5. Turn on the unit using the mains power switch (position “1”).
As soon as the printer is ready, the following appears:
¯ If SYSTEM PARAMETERS > Turn-on mode is set to “Online”, the printer
switches directly into online mode after turning on the printer!
WARNING!
This unit operates at mains voltage! Contacting electrically live components
can cause potentially lethal electrical shocks and burns.
« Make sure that the machine has been switched off before connecting the
mains cable.
« Only operate the printer at the mains voltage given on the type plate.
« Only connect the printer to a properly installed mains socket with protec-
tive earth.
« When installing the mains cable, ensure the following:
a) Nobody can stumble over the cable
b) Mains plug can be pulled in case of emergency
OFFLINE 0 JOBS
B
A
C