Avery Dennison AP5.6 - Configuring Data Interface; Internal Rewinder

05/10 Version 5.05-00 USER MANUAL Commissioning and Operation
AP5.4 – AP5.6
17
Configuring the data interface
The AP5.4/5.6 has been pre-configured at our factory for data transmission
through the USB port. Alternatively, printer data can also be transmitted via
RS232, RS422/485 (only with optional I/O board), USB or Ethernet port.
« Choosing the port: INTERFACE PARA > EASYPLUGINTERPR > Interface
« Configuring the port:
• RS232 (COM1): INTERFACE PARA > COM1 PORT > …
• RS232/422/485 (COM3): INTERFACE PARA > COM3 PORT > …
• Ethernet: INTERFACE PARA > NETWORK PARAM. > …
¯ We recommend that your network administrator configures the network
settings.
• USB: no configuration required
For more information on how to set the parameters, see topic section “Info
Printouts and Parameters”, Operating the Parameter Menu .
The order numbers for network and data cables are given in topic section
Accessories .
For more information on how to use the Ethernet port, see topic section
“Advanced Applications”, chapter Data Transmission with Ethernet  on
page 18.
(De)activating the internal rewinder
¯ Only applies to AP 5.4/5.6 dispensers with baffle plate installed.
Activate
¯ Ensure that material has been inserted before you activate the rewinding
function, otherwise a fault message will appear!
For information on inserting material, see topic section “Setup”, chapter
Inserting Label Material  on page 6.
Set
1. SYSTEM PARAMETER > Periph. device to “Intern Rewinder”.
¯ Do not confuse this with “Rewinder” because this setting activates the
external rewinder (additional device)!
After being activated, the system checks the direction of rotation of the re-
winder.
“Facing outside” is set by default.
2. If required, press the cut/feed button to change the direction of rotation.
3. Press the ENTER button to confirm your selection.
The printer restarts. Afterwards, an additional menu REWINDER PARA can
be opened from the main menu, and this contains the Rewind direction para-
meter. Using this parameter, you can change the direction of rotation.
Rewinder direct.
Facing outside