05/10 Version 5.05-00 USER MANUAL Commissioning and Operation
AP5.4 – AP5.6
18
During the initialisation, the printer attempts to tighten the label strip.
Deactivate Set
« SYSTEM PARAMETER > Perip. device to “None”.
Possible fault The following error message may appear briefly after activating the internal re-
winder:
Possible causes include:
• No material has been inserted or end of material has not been fastened to
rewinder. Fasten end of material to rewinder and press Online button.
• The material strip is sagging in front of the rewinder. Press the Online
button.
Modifying main
initialisation
After this, the printer is ready for the first job. As soon as a job is received, the
rewinder controller calculates the main initialisation values for the rewinding
process on the basis of the given material width and printing speed. These val-
ues are suitable for a wide range of applications.
However, these settings may cause too much printer offset in certain special
applications. In these cases, the main initialisation values will have to be modi-
fied. Such applications include printing on:
• Very narrow labels
• Very coarse backing paper
• Very thick backing paper compared to the label
• Labels stuck on the backing paper
• Backing paper perforated along label contour
¯ Only qualified service technicians are permitted to edit the main initialisa-
tion values!
Status 5004
Rewinder mat. tear
To Next Page
Loading...
