05/10 Version 5.05-00 USER MANUAL Commissioning and Operation
AP5.4 – AP5.6
6
[6] Operating controls of AP5.4/5.6.
A Ribbon unwinding mandrel:
Holds the new ribbon roll
B Ribbon winding mandrel
Holds the cardboard core that rewinds the spent ribbon.
C Connection flange for additional devices
You can fasten either a cutter or rewinder (AP5.4 only) here. To do this,
you first have to remove the plastic cover.
D Pressure lever
Opening the pressure lever lifts the printhead. You do this to insert materi-
al/ribbon or to clean the printhead/print roller.
E Material unwinder
This is where you install the roll with the label material.
F Material strain relief
Allows the label material to unroll evenly.
G Guiding disk
Prevents material roll from sliding out sideways.
H Adapter rings
For adapting unwinder to core diameter of material roll.
B
A
C
D
E
F
G
H
To Next Page
Loading...
