Chapter 4: Hardware Connections 11
chapter 4
Hardware Connections
To hear audio recorded from Fast Track C400,
you will need to connect headphones or an ex-
ternal sound system (such as powered monitors
or a home stereo) to Fast Track C400. Sound
from Fast Track C400 cannot be played through
your computer’s speakers or your computer’s
sound output.
Connecting Headphones
On the front panel of the Fast Track C400 is a
1/4-inch jack to connect headphones. The vol-
ume level of the headphone signal is controlled
by Headphone Volume knob on the top panel.
Connecting a Sound System
The Line Outputs on your Fast Track C400 are
grouped in pairs that correspond to the top-
panel Output Selector buttons A and B.
These connections support 1/4-inch balanced
TRS (Tip, Ring, Sleeve), or unbalanced unbal-
anced TS (Tip, Sleeve) connectors. These outputs
can be connected to any amplification system:
powered speakers, a home stereo system, or an
audio mixer.
Please refer to your audio application's doc-
umentation to learn how to route signals to
and from Fast Track C400
Headphone jack on Fast Track C400 front panel
Home stereo systems often use RCA connec-
tors. You can use adaptors or a cable to con-
vert from the Line Output connectors on
Fast Track C400 to the RCA connectors on
your home stereo.
Fast Track C400 Stereo outputs A and B (back panel)
To Next Page
Loading...
Need help?
General
