Fast Track C400 User Guide36
Recording Instrument Tracks
This section shows you how to record a software
or virtual instrument track in your software.
To record an instrument track:
1 If you are using a MIDI controller, make sure
you have made the correct MIDI connections as
described in “MIDI Connections” on page 16.
If you are using a USB-based MIDI controller
such as an M-Audio Axiom® or Oxygen key-
board from Avid, make sure you have properly
installed and connected the device as described
in the User Guide for that product.
2 Create a new Instrument (or MIDI) track in
your recording software, or choose an existing
track to which you want to record.
3 Load a software instrument onto the track.
4 Press the record enable button for that track.
5 Press the Multi button on the top panel of
your Fast Track C400 to begin recording.
6 When you have finished, press the Multi but-
ton to stop recording.
7 Press the Multi button a third time to save
your work.
8 Press the Multi button twice more to go back
to bar 1 and play back what you’ve recorded.
USB-based products send and receive MIDI
signals through the USB cable and do not
need to be connected to MIDI ports of Fast
Track C400.
Refer to your software documentation for
more detailed information about creating a
virtual or software instrument track, how to
load an instrument, and record enabling (re-
cord arming) the track.
Steps 5 through 8 will only work if you have
configured the Multi button as described in
“Configuring the Multi Button (Building a
Macro)” on page 32.
To Next Page
Loading...
Need help?
General
