Chapter 4: Using the Driver Control Panel 31
FX Returns
These knobs control how much of the Effect au-
dio output is mixed in with the monitor signal
Master L/R outputs. Unlike sends, FX Returns
are individually adjustable for each stereo mix.
The Clip LED shows clipping if the input to the
FX is clipping and if the output is clipping (the
rest of the meter is just output).
Effect
The Effect drop-down menu is used to select the
effect to be applied to the Hardware Inputs
and/or Software Returns. There are five available
reverb types: Three room reverbs and two hall
reverbs, delay, and echo. These effects can be
customized by using the following three con-
trols:
Duration This knob controls decay time (for the
reverbs) or delay time (for delay and echo).
Feedback This knob controls the number of re-
peats for the delay and echo effects. It does not
affect the reverbs.
Volume This knob controls the effects output
level being sent to the FX Returns.
Master
The Master section is for monitoring the main
mixer output. This output can be routed to any
hardware output. Each Stereo Mix includes mas-
ter section with several controls:
Master Fader Adjusts the overall level of the ste-
reo mix.
Balance Knob Adjusts the left/right balance of
the stereo mix (double-click the knob to return
it to center).
Width Knob Adjusts the width of the stereo im-
age, where fully counter-clockwise is mono, and
fully clockwise is full stereo (double-click the
knob to return it to center).
Mute Buttons Mutes the left and/or right side of
the stereo mix.
To Next Page
Loading...
Need help?
General
