S6L-24C and S6L-16C 23
S6L-24C/16C Only
In the next step you will lift the Tray out of the chassis and hang it off the back edge of the console chassis. You should not need
to disconnect any cables before lifting the Tray out, but you may need to guide one or more of them away to allow the Tray to be
lifted out of the chassis. If you find you do need more slack, note and/or label and then disconnect any cable that is not long enough
to allow the Tray to be lifted out of the chassis.
8 Being very careful to not stretch any cables, use two hands to lift the tray out of the chassis. Tilt the Tray as needed to clear the
chassis, and make sure no cables are caught or stretched.
9 Align the edge of the Tray with the edge of the chassis as shown in Figure 36 so that the Tray hangs off the chassis.
Figure 35. Lifting the Tray out of the chassis
The image shown below is of an older series control surface.
Figure 36. SBC Tray hung off the back edge of the chassis
To Next Page
Loading...
Need help?
General
