EN
5
EN
4
In our efforts to continually improve our products,
we reserve the right to make any changes to the
technical, functional, or aesthetic characteristics
related to their development.
This automatic gate opening mechanism, and
its manual, were designed to enable a gate to be
motorised in compliance with current European
standards.
WARNING
Important safety instructions. A automatic gate
opening mechanism is a product that can cause
injury to people and animals and damage to
property. It is important for people’s safety to follow
these instructions and keep them.
1 - OPERATING PRECAUTIONS
• This apparatus may be used by children over the
age of 8 and by persons with reduced physical,
sensory or mental abilities or lack of experience or
familiarity,
if they are correctly supervised
or if the
instructions relating to the safe use of the apparatus
have been given to them and the possible hazards
are understood. Children must not play with the
device. Keep the remote controls out of the reach
of children. Cleaning and maintenance must not
be conducted by children without supervision.
• This apparatus should only be used for its intended
purpose, that is, to motorise a one- or two-panel
gate for vehicle access. Any other use will be
considered dangerous.
• The opening or closing manoeuvre control must
be used with perfect visibility of the gate. Should
the gate be outside the user’s field of vision, the
installation must be protected by a photocell type
safety device, and its operation must be checked
every six months.
• All potential users must be instructed in the use
of the motorised gate by reading this manual. It
must be ensured that no persons who have not
been instructed in the use of the device may set
the gate into motion.
• Before setting the gate into motion, ensure that
there is no person in the area in which the gate
moves.
• Avoid any natural obstacles (branch, stone, high
grass, etc.) impeding the gate’s movement.
• Do not manually activate the gate when the motor
drive is not disengaged from the gate.
• Avidsen cannot be held liable for any use that does
not comply with the instructions in this manual and
causes damage.
2 - OPERATING PRECAUTIONS
• Read this entire manual before starting the
installation.
• The electrical installation of the motorised gate
must meet current standards (in particular NF C
15-100) and should be undertaken by a qualified
person.
• The 230 V mains supply must be protected with
a suitable circuit breaker which meets current
standards.
• All electrical connections must be performed
with the power switched off (safety switch in OFF
position) and battery disconnected.
• Ensure that crushing and shearing between
the mobile parts of the motorised gate and the
surrounding fixed parts due to the gate’s opening/
closing movement are avoided or signalled on the
installation.
• The motorised part must be installed on a gate
according to the specifications provided in this
manual.
• The motorised gate must not be installed in an
explosive atmosphere (presence of gas, flammable
smoke, etc.).
• The installer must check that the temperature
range shown on the motor drive is suitable for the
location.
• The wire that acts as an antenna must remain
inside the electronic panel.
• It is strictly forbidden to modify any of the
components provided in this kit, or to use an
additional component not provided for in this
manual.
• During installation, but above all during adjustment
of the motorised gate, you must ensure that no
person, including the installer, is in the area in
which the gate moves at the start and throughout
the duration of adjustment.
• The flashing light is an essential safety component.
• If installation does not correspond to one of the
A - SAFETY INSTRUCTIONS
To Next Page
Loading...
