(Optional) Configuring microSD Card Storage
To use the camera's SD card storage feature, you must insert an microSD card into the card slot.
It is recommended that the microSD card have a write speed of class 10 or better. If the microSD card does not
meet the recommended write speed, the recording performance may suffer and result in the loss of frames or
footage.
1. Insert a microSD card into the camera.
CAUTION — Do not force the microSD card into the camera or you may damage the card and the
camera.
2. Access the camera’s web interface to enable the onboard storage feature. For more information, see the
Avigilon High Definition H.264 Camera Web Interface User Guide.
Mounting the Dome Camera
Mounting the Dome Camera to a Ceiling or Wall
Perform the following steps if the required cables will be coming from inside the mounting surface and the
camera will be mounted immediately over the cable hole. Use this procedure on surfaces that can be easily
drilled into, and when the cables should be kept out of sight.
If you do not need to use the auxiliary cable, skip the relevant steps.
1. Using the Camera Base Mounting Template, drill 3 pilot holes into the mounting surface.
If you are mounting the camera to a wall, make sure the pilot hole for the primary mounting slot is at the
top, or the video image will be rotated.
2. Hammer the supplied plastic anchors into the holes.
3. Drill the 2 cable entry holes into the mounting surface.
4. Pull the required cables through the mounting surface.
(Optional) Configuring microSD Card Storage 10
To Next Page
Loading...
