9. Insert the provided Torx screw through the primary mounting slot in the camera base, and into the now
visible hole in the mounting bracket.
10. Tighten the screw to lock the camera to the bracket.
Mounting the Dome Camera to an NPT Pipe
Perform the following steps if the dome camera needs to be installed to an NPT pipe for a pendant installation.
To perform this procedure, you need the optional NPT adapter (H4F-MT-NPTA).
If you do not need to use the auxiliary cable, skip the relevant steps.
1. Pull the required cable through the NPT conduit pipe.
2. Apply thread seal tape to the pipe and screw on the 1-1/2” NPT female to NPT female pipe adapter.
3. Screw the lock nut onto the NPT adapter.
4. Apply thread seal tape to the NPT adapter and screw it into the pipe adapter.
Make sure the parts are assembled in this order from NPT conduit pipe to camera adapter:
a. NPT conduit pipe
b. 1-1/2" NPT female to female pipe adapter
c. Lock nut
d. NPT adapter
Mounting the Dome Camera to an NPT Pipe 21
To Next Page
Loading...
