9. Align the mounting slots on the camera base to the camera posts on the bracket, then twist counter-
clockwise until the posts come to the right end of the mounting slots.
A tapped hole is now visible through the left side of the primary mounting slot on the camera base.
10. Insert the provided Torx screw through the primary mounting slot in the camera base, and into the now
visible hole in the mounting bracket.
11. Tighten the screw to lock the camera to the bracket.
Mounting the Dome Camera to an Electrical Box
Perform the following steps if the required electrical components and cables must be contained in an electrical
gang box. To mount the dome camera to an electrical gang box, you must use the provided bracket.
Mounting the Dome Camera to an Electrical Box 17
To Next Page
Loading...
