We are Partners – Areas of Application
1–4 ©1998 AViTEQ Vibrationstechnik GmbH Version 02/2003
1.3 Areas of Application
VIBTRONIC controllers of type SC…-2 and SCE…-2 – hereafter abbreviated with
SC(E)…-2 – make possible the stepless adjustment of the working stroke on the
magnetic vibrator and, thus, of the conveyor rate of vibration conveyor devices.
The controllers must be used together only with AVITEQ magnetic vibrators or
equivalent magnetic vibrators produced by other manufacturers in accordance
with their intended use. Information in the vibration conveyor device and the mag-
netic vibrator operating manuals is also to be observed!
The controllers must only be operated with magnetic vibrators produced from third
party manufacturers when their connection specifications are identical to those of
the AViTEQ magnetic vibrators. For more information, see Chapter 5.2!
The controllers are not intended for any other purposes.
Never use in the following cases:
l
Do not use for operation in environments subject to explosion risk or firedamp
(explosives, (pit-) gas, risk of dust explosion)! The units are not explosion-
protected!
l
Do not use at ambient temperatures below -5 and over +40 °C (cabinet unit)
and +50 °C (panel mounting unit), or in tropical climates or areas where dew
or condensation could form! The units are designed for operation in moderate
climatic environments!
l
Do not use together with magnetic vibrators which are not compatible with
the controllers!
l
Do not use mains networks and mains frequencies other than those for which
the controllers were designed!
l
Do not use at elevations above 1,000 m above sea level without first consult-
ing AViTEQ Vibrationstechnik GmbH!
Connecting to mains and magnetic drives
Only AVITEQ controllers connected to a sinusoidal mains network may be used for
operating the AVITEQ magnetic drives. For each AVITEQ magnetic drive model
there is a corresponding controller.
Other control and connection options are not included.
If a magnetic vibrator is directly connected to mains or an inappropriate controller
is used, the magnetic vibrator may be destroyed. Only use the appropriate control-
ler!
To Next Page
Loading...
Need help?
General
