Operating Manual for Controller VIBTRONIC
®
SC(E)…-2
©2002 AViTEQ Vibrationstechnik GmbH Version 02/2003 1–1
1
1 We are Partners
1.1 About this operating manual
For whom?
This operating manual is intended for the
l
installation technician who installs and commissions the magnetic vibrator.
l
electrician or engineer who carries out the installation of the controller, the
electrical connection to the mains network and the connection to the mag-
netic vibrator.
All work on the controller must be carried out by qualified personnel (electricians
or persons trained in electrical engineering according to IEC 364 and
DIN EN 60204-1).
Additional Publications
Supplements to this Operating Manual:
l
Connection diagram and dimension sheet for the controller
Definitions
l
Magnetic vibrator: electromagnetic-mechanical unit for operating a vibration
conveyor device
l
Vibration conveyor device: unit consisting of the magnetic vibrator and work-
ing unit (trough, tube, helix, screen etc.)
l
Controller: the separately delivered electronic control unit assigned to the
magnetic vibrator for connecting to the mains network
l
Cabinet unit: controller in compact housing for wall or frame mounting
(type SC…-2)
l
Panel mounting unit: controller for installation in the switching cabinet or in an
enclosed control location (type SCE…-2)
This operating manual applies to the panel mounting unit. Variations specific to the
cabinet unit are indicated at the appropriate points.
Special symbols in this operating manual
Earlier in this manual, you should have learned how we indicate safety notices.
If you have any questions about safe work practices regarding controllers and
their environment, you should give us a call! We do not want you to endanger
yourself or others just because the possible dangers were not clear to you!
NOTE
Date of Revision
On the bottom in the right-hand-side
pages of this operating manual, the ver-
sion number tells you the date when the
page was last updated.
To Next Page
Loading...
Need help?
General
