Operating Manual for Controller VIBTRONIC
®
SC(E)…-2
©2002 AViTEQ Vibrationstechnik GmbH Version 02/2003 3–3
3
3.3.4 Operating Messages
For displaying operating states, the units are provided with two LEDs at the top of
the front panel.
The operating condition displays are explained in Figure 3.1.
3.4 Models
The controllers are deliverable in sizes "CN", "DN", "EN", and "ES" in the following
models:
l
Cabinet unit SC… (IP 55): closed compact housing for wall or frame mount-
ing. Vibration-width adjuster and mains switch are installed on the front side
of the housing.
l
Panel mounting unit SCE… (IP 20): controller for installing in switching cabi-
nets or in closed control locations
The corresponding technical data are located in Table 3.2:
SC(E)-C..-2 SC(E)-D..-2 SC(E)-E..-2
Mains frequencies 50 or 60 Hz
Vibration frequencies with 50 Hz mains 25 or 50 Hz
Vibration frequencies with 60 Hz mains 30 or 60 Hz
Nominal voltages with 50 Hz mains
and 60 Hz mains
220 … 240 V
380 … 420 V
440 … 480 V
500 … 520 V
Nominal current 15 A
Maximum power loss
in switching cabinet
45 W
Table 3.2 Technical data for type SC(E)…-2 controllers
LEDs light up, if …
mains voltage is present.
vibrator voltage is present at terminals 3 and 4.
Power on
Run
Operation
(green)
Figure 3.1 Display of operational states by LEDs
To Next Page
Loading...
Need help?
General
