Operating Manual for Controller VIBTRONIC
®
SC(E)…-2
©2002 AViTEQ Vibrationstechnik GmbH Version 02/2003 2–2
2
Unauthorised combinations may result in destruction of the magnetic vibrator or
controller! Mains voltage, mains frequency and vibration frequency must be identi-
cal! The nominal current of the controller must be the same or greater than the
peak current of the magnetic vibrator. Only connect compatible devices!
2.2 Disposal
2.2.1 Packing Materials
The following materials are used by us for the shipping of controllers, depending
on the mode of transport:
l
Polyethylene foil (PE) for device protection
l
Corrugated cardboard for outer and inner packing
l
Wooden cases for outer packing
l
Paper shavings for filler material
l
Styrofoam (Flo-Pack) for filler and damping material
All packing materials should be disposed of in accordance with local regulations of
the delivery destination.
Cardboard containers and paper packing tapes can be recycled within the RESY
Disposal and Re-utilisation System. Where used, packaging foil, packing tapes,
and foam foils are made from polyethylene (PE), the CFC-free cushions are usually
made from polystyrene foam (PS). These packing materials consist of pure hydro-
carbons and can thus be recycled.
In special cases, we use steel packing bands and wooden cases free of chemical
treatment.
2.2.2 Returning the Device
AViTEQ Vibrationstechnik GmbH takes back without charge controllers of type
SC(E)…-2 delivered in 2002 or later when delivered shipping paid to AViTEQ Vibra-
tionstechnik GmbH, D-65795 Hattersheim-Eddersheim.
To Next Page
Loading...
Need help?
General
