Room Monitoring (Baby Monitor)
FRITZ!Box Fon WLAN 7170 – 11 Configuration and Operation by Telephone 107
Room Monitoring (Baby Monitor)
The following key sequence enables the function for monitor-
ing the sound level in a room. First enter the volume level (a
value between 1 and 8). Enter a telephone number. Do not
hang up the handset! When the volume in the room reaches
the specified level, the number you entered will be dialed.
When the telephone rings and you pick up the handset, you
will be connected with the telephone on which you enabled
the room monitoring function.
It is preferable to use the speaker phone function.
You can disable the function by simply hanging up the hand-
set of the telephone at which you enabled it.
Dial the number of the extension to listen in at an extension
with room monitoring activated.
After initiating a room monitoring phone call, the PBX cannot
generate a new call until at least one minute has lapsed.
N
Pick up the handset or activate the
speaker phone function of your tele-
phone.
s4 level s number r Dial the sequence shown at left. For
“level”, enter a number between “1”
(the most sensitive sound level) and
“8”. For “number”, enter the number
to be called. This may be the number
of another internal extension, a “9” for
an internal group call, or any external
number desired.
Q
Wait for the acknowledgement tone.
The baby monitoring phone function is
now enabled.
Do not hang up the handset!
To Next Page
Loading...
Need help?
General
