Avocent CPS1610 User Manual

54 CPS Installer/User Guide
Example
The following command updates the boot image program using the image file name
c:\winnt\system32\drivers\cps10bt.img, which is located on the TFTP server host located at
192.168.1.16.
> ser fla app hostip=192.168.1.16
c:\winnt\system32\drivers\ima=cps10bt.img
Server Ping command
The Server Ping command enables or disables response to ping requests. When enabled, the CPS
appliance receives and responds to all ping requests. When disabled, ping requests are received and
silently discarded.
Syntax
SERVER PING [ENABLE|DISABLE]
Server PPP command
The Server PPP command enables or disables the PPP server on the serial CLI port. For more
information, see Connecting to devices using PPP on page 15.
Once the PPP server has been configured with this command by specifying the required addresses
and masks, those values remain in the database. Later, if you disable the PPP server and wish to
reenable it with the same addresses, you don’t need to specify the address values again.
When you enable the PPP server, the serial CLI port must already be defined.
When you enter this command, you are prompted to confirm or cancel the specified changes.
Access right: SCON
Access level: APPLIANCEADMIN
IMAGE=<host_file> Name of file on TFTP server host containing the image file.
Table 5.12: Server FLASH Command Parameters (Continued)
Parameter Description
Table 5.13: Ping Command Parameter
Parameter Description
ENABLE|DISABLE
Enables or disables response to the ping requests.
Default = Enabled

Avocent CPS1610 Specifications

General

Brand	Avocent
Model	CPS1610
Category	Network Hardware
Language	English