Avocent CPS1610 User Manual

56 CPS Installer/User Guide
Examples
The following command specifies primary RADIUS server information; default values will be used
for the UDP port, time-out and retries values.
> ser radius primary ip=192.168.0.200 secret=ThePrimaryRadSecret user-
rights=86
The following command deletes the primary RADIUS server definition.
> ser radius primary del
Server Reboot command
The Server Reboot command reboots the CPS appliance. During a reboot, any active Telnet
sessions, including your own, are terminated, and all users are informed accordingly. Any
configuration changes that require a reboot will become effective when the reboot completes.
When you enter this command, you are prompted to confirm or cancel the reboot.
Access right: SCON
Access level: APPLIANCEADMIN
Syntax
SERVER REBOOT
Table 5.15: Server RADIUS Command Parameters
Parameter Description
PRIMARY|
SECONDARY
Indicates either the primary RADIUS server or the secondary RADIUS server is
being defined or deleted.
IP=<radius_ip> IP address of the RADIUS authentication server.
SECRET=<secret>
8-24 character text string for shared secret with the RADIUS server. Enclose the
string in quotes if it contains spaces.
USER-RIGHTS=<attr> Attribute number defined on the RADIUS server, in the range 1-255.
AUTHPORT=<udp>
UDP port for RADIUS authentication server, in the range 1-65535. This value is
usually 1645, but may be 1812.
Default = 1645
TIMEOUT=<time-out>
Number of seconds to wait for a response from the RADIUS server, in the range 1-60.
Default = 5
RETRIES = <retry>
Number of attempts to make to authenticate a user after a time-out, in the range 1-10.
Default = 3
DELETE Deletes the RADIUS server definition.

Avocent CPS1610 Specifications

General

Brand	Avocent
Model	CPS1610
Category	Network Hardware
Language	English