14
Step2: Click “Add” again to add more preset points.
To modify the existing preset point setting, click “Edit”. To insert a preset point before the selected point,
click “Insert”. To remove the added preset point, click “Delete”.
Step3: When all the points are added, click “Save” to confirm.
3.3.4 Color
Adjust the color performance from Brightness, Contract, Hue and Saturation. Click and drag the slider to preview
the color change on the right side of ths page and adjust the image color.
To restore the default values, click “Back to Default”.
3.3.5 LED
In “LED Configuration”:
To allow the LED light to be activated manually, select “Yes” in “Manual Enable”.
To set the LED light to be activated automatically when the light condition gets dark, select “Yes” in “Auto
Enable”, and set the sensitivity for the camera to determine how dark the LED light should be activated.
There are three options: HIGH / MEDIUM / LOW.
In “LED Timer Configuration”:
To schedule the white LED light to be enabled, go to “LED Timer Configuration”, select “Yes” in “Enable”, and set
the time to enable the LED light. Each square equals 30 minutes.
To Next Page
Loading...
Need help?
General
