16
3.5 Storage
3.5.1 SD Card
In “SD Card”, you can check the current status of your micro SD card, and clear all recorded data saved in the
card if needed.
3.6 Trigger
3.6.1 Trigger
You can configure how this camera reacts when there’s an alarm, motion, PIR and audio event.
Detect
Item Description
External Alarm Set “N.O.” or “N.C.” depending on the configuration of your alarm-in device.
Motion Enable (ON) or disable (OFF) motion detection.
Motion detection is not supported when the stream format is Motion JPEG.
When “Enable” is selected, click “Detection” to enter the motion detection area setting page as follows:
Level of Sensitivity:
Set the detection sensitivity from 1 ~ 10.
Area Setting:
Set the motion detection area by selecting the area grids with your mouse. Pink grids represent the area that is not being
detected while the transparent grids are the area under detection. You can set multiple areas under detection.
Click “Clear All” to set the whole area undetected.
Click “Select All” to set the whole area under detection.
PIR Enable (ON) or disable (OFF) PIR detection.
For Push Video to work properly, make sure this function is enabled.
To Next Page
Loading...
