MAIN MENU
28
result will display in “CONNECTION”.
2) MENU
Click “SETUP” to configure the connected zoom lens control camera.
Different zoom lens control cameras might have different parameter settings. For details, please refer to their
own user manuals.
Note: While configuring the camera parameters, the DVR will switch to the corresponding channel, and
you can simultaneously preview the effects for the settings.
3) DEVICE
Here shows the model number of the camera.
4) CONNECTION
Here shows the examining result for DCCS signal transmission between the DVR and camera. The
message is as follows:
MESSAGE SHOWN MEANING
CHECKING The DVR is checking the DCCS signal transmission between the DVR and camera.
OK The signal transmission is fine and the DCCS function works properly.
FAIL The signal transmission is too weak or not available for the DCCS function to work properly.
5.5.10 IVS
IVS, Intelligent Video Surveillance, is the advanced application for motion detection, but more precise and smarter.
It can be applied to different situations with one of the following three modes: FLOW COUNTING, VIRTUAL
FENCE, and ONE WAY PASS.
When anyone crosses the detection line (virtual fence), the recording will be on.
Note: Four camera channels are supported for this function. For 16CH and 8CH models, users are
allowed to select four camera channels randomly to use this function; for 4CH models, all the four
camera channels are supported.
ADVANCE CONFIG
C A N E R A IVS1 IVS2 IVS3
DETECTION CAMERA (For 16CH & 8CH models only) CH3
ALERT IVS MODE FLOW COUNTING
NETWORK DISPLAY LINE OFF
SNTP SENSITIVITY 07
DISPLAY RESET COUNT SUBMIT
RECORD VIRTUAL FENCE AREA SETUP
REMOTE SCENE CHANGE OFF
DCCS SCENE CHANGE SENSITIVITY MIDDLE
IVS
NOTIFY
EXIT
1) CAMERA (For 16CH & 8CH models only)
Select the camera channel that you want to use the IVS function.
2) IVS MODE
Select one of the following three modes depending on your environment:
MODE DESCRIPTION
FLOW COUNTING A virtual detection line is set to detect the moving direction of pedestrians for flow counting.
VIRTUAL FENCE A virtual detection line is set to detect intruders crossing the detection line, and an alarm will be
triggered.
ONE WAY PASS A virtual detection line is set to detect intruders from the specified direction, and an alarm will be
triggered.
To Next Page
Loading...
Need help?
General
