BEFORE USING THIS DVR
3
6) CALL
Connect to a monitor specific for sequence display.
7) VGA
Connect to a LCD monitor directly.
Note: When both MONITOR and VGA are connected, press the right key ► on the DVR front panel during
DVR power-on to force the video output via VGA. For details, please refer to “5.5.6 DISPLAY” at
page 25.
8) IR
Connect the IR receiver extension line for remote control.
9) EXTERNAL I/O
This port is used to connect external devices (such as speed dome cameras or external alarm, etc).
For detailed I/O port PIN configuration, please refer to “APPENDIX 2 PIN CONFIGURATION” at page 53.
10) LAN
Connect to Internet by LAN cable.
11) DC 19V
Connect to the supplied adapter.
12) Power Switch
Switch to “\” to turn on the power, and “|” to turn off the power.
To Next Page
Loading...
