Avtron ADDvantage-32 - Bit Select; Bit Select Block

Control Block Description ADDvantage-32
4-21
4.15 BIT SELECT
This block is used to select one of two different bit signal paths.
FIGURE 4-15. BIT SELECT BLOCK
1. Inputs
INPA: Bit
INPB: Bit
SEL A: Bit
2. Outputs
OUT: Analog
3. Implementation
If SEL A bit is high (set at 1), OUT is equal to INPA.
If SEL A bit is low (set at 0), OUT is equal to INPB.