ADDvantage-32
Advanced Control Module (ACM)
9-1
SECTION IX
SYSTEM DATA STRUCTURES
This section details the data structures of all necessary
tables and data inputs used to set up and define operation of
an ADDvantage-32. Some parameters are write protected,
meaning the information is read only and cannot be written
to. If a write is attempted on a protected area, an error
message appears. All parameters, regardless of write-protect
status, can be read over the serial link or 802.4 LAN.
For additional information on communicating to an
ADDvantage-32, refer to Avtron Engineering Report 14363-001
for the RS-485 serial link or the Avtron ADDvantage-32 LAN
Specification. These reports can be obtained upon request.
9.1 DATA TABLES
Information in the ADDvantage-32 is accessed using tables
(Files). Each table contains a specific group of parameters
or information associated with those parameters. For example,
one table contains the numerical data for all the C***
parameters while a second table contains the units for these
parameters.
9.2 DATA TABLE STRUCTURES
Data tables for the ADDvantage-32 start at number 9. Each
element referenced in the table can be found by referencing
its parameter number in Appendix C.
***************************************************
C A U T I O N
Data contained in the ADDvantage-32 data
tables depends on the software part number and
version being used by the unit. Each software
part number uses different parameters and
numbers. To locate a particular parameter
within a table, find the table number that
contains the parameter information required.
Refer to Appendix C to locate the parameter
number and its position in the table.
***************************************************
***************************************************
To Next Page