Problem Solving
Installation Guide - Model 60E 19
Failure to light when the terminal is switched on may be due to any of the
following:
- the Ethernet cable is disconnected at the far end,
- the device (host or hub), to which the network cable is connected, is
not switched on,
- there is a fault on the Ethernet cable or the cable is wired with
incorrect pin assignments.
9 - NO LOGIN WHEN THE 'CONNECTING...' MESSAGE IS DISPLAYED
Check the Ethernet cables are correctly connected and networked devices
(hubs or servers) are switched on.
No connection (and no login) can also be due to a wrong terminal setting
during the TCP/IP set-up (for example a wrong IP address).
9 - THE CONNECTED PRINTER DOES NOT WORK
Check that the cable pin assignment is correct and that the port being used
(AUX1, AUX2 or PARALLEL) has been correctly selected in AX3000
Set-Up.
Test the printer in local mode by selecting the [TEST] button within the
auxiliary port dialog box.
To Next Page
Loading...
Need help?
General