OXYGEN 1000 & OXYGEN 2000 · User Manual · ENG
OXYGEN 1000 & OXYGEN+ 2000 INSTALLATION NOTE AND FIRST STEP |PROTECTION AGAINST
LIGHTNING
OXYGEN 1000 & OXYGEN+ 2000 INSTALLATION NOTE AND FIRST STEP
Best setup location
Oxygen 1000 & Oxygen 2000 should be installed avoiding direct sunlight, close proximity to radiators
and air conditioning, dust, water, and chemicals. Choose a console location that permits a clear view
of the indicators on the device and ensures a sufficient heat dissipation of the device.
Power supply
The device is designed for operation with 100 to 240 VAC, 50 Hz to 60 Hz. Check the corresponding
device labelling for compatibility with the domestic line voltage and frequency before connecting the
IEC power connector to the mains supply!
Please make sure that the device and the contained fuse(s) (please
see p. 17) are compatible with the domestic line voltage and
frequency. If the device is compatible, connect the power supply cord
fully to the IEC power connector at the rear side of the device and a
mains power outlet. The “LCD Screen” will then turn on.
OXYGEN has a display, so you can configure the IP settings directly:
See step “LAN-1 PAGE FUNCTIONALITY (HOW TO SET THE TCP/IP ETH-
1)”
Connect a network patch cable to the “10/100-Base-T” connector on
the rear side of the device and your existing IP network.
These first steps are only intended for a quick first start and do not
cover all device functions. Please read carefully the entire manual to
be able to use all functions of the device.
WARNING
Disconnect the mains power plug before you open
the housing. Repair of the equipment must only be
carried out by authorized and qualified personnel.
To Next Page
Loading...