Axis 200 - Page 31

AXIS 200 User’s Manual Section 4: Configuring the AXIS 200
29
Modem Page
To enable a serial link to the AXIS 200, click Modem at the top of the
Configuration page. This is needed if you want to transfer snapshots
and configuration data via a connecting modem.
The following is a description of the Modem parameters:
To ensure that the new configuration is activated within the AXIS
200, you must reset the unit after the serial mode has been enabled.
To do this, remove and then re-insert the power connector.
Alternatively, type this command in the location/address field:
Note:
❏ Do not enable serial mode unless you intend to connect your
AXIS 200 to a modem.
Refer to “Setting Up the AXIS 200 Modem Server” on page 78 for more
information on how to connect the AXIS 200 to a modem.
Parameter name Description
[Mode]
Serial Mode When set to Disabled, PPP or zmodem access is not available.
When set to Full Support, serial mode is enabled for both
incoming and outgoing modem connection. When set to
Inbound only, the AXIS 200 answers incoming calls, but does
not dial up. When set to Outbound only, the AXIS 200 dials up
according to the behavior programmed in the cronscript, but
does not answer incoming calls.
[Settings]
Modem Type Autodetected Modem or Null Modem.
Detected Modem Set internally by the AXIS 200.
Modem Init String String of setup commands to be sent to the modem. Used for
non-US Robotics modems.
Busy Redial
Attempts
Specifies how many additional attempts the AXIS 200 will
make in order to establish a connection in case the line is busy.
Baud Rate 19200 or 38400 is recommended. When used with
GSM/cellular phones, always set the Baud rate to 9600.
Dial Prefix Specifies whether your modem is using tone dialing or pulse
dialing. The default is Tone Dialing which is the most
commonly used method.
Flow Control Modem server operation mode. Always set to XON/XOFF.
http://<cameraname>/hardreset/