AXIS 200
User’s Manual Appendix F: The RS232 Serial Port
79
CTS/RTS
In future releases of the software, the CTS/RTS handshaking will be
supported. However, to enable this mode of transmission in current
versions of the AXIS 200, the wiring schedule for the connecting
RS232 cables must look like this:
Note:
❏ Some modems are supplied with a cables terminated by 25 pin
DSUB connectors at both ends. Should you have a cable similar
to this, you will need to use a 25 pin Male - 9 pin Female 'gender-
bender' with the pin assignment detailed above. Null modem
cables will not work!
AXIS 200 signal
name
AXIS 200
(9 pin
DSUB Female
connector)
Modem
(25 pin
DSUB Male
connector)
NC 1 8
-RXD 2 3
-TXD 3 2
RTS 4 20
GND 5 7
CTS 6 6
RTS 7 4
NC 8 5
NC 9 22
To Next Page
Loading...
