Appendix F: The RS232 Serial Port
AXIS 200 User’s Manual
80
Configuring your
modems
Before files can be transferred from your AXIS 200, the host and
remote modems must be configured correctly.
Follow these instructions to configure a US Robotics 28k8+ modem:
1. Connect the modem to your terminal.
2. Check that the modem is responding by issuing the
at
command.
3. Continue your configuration in accordance with the session
detailed below (user commands are written in
bold
text):
4. To make sure that your modem reloads the established settings on
each occasion it powers up, issue the
ati4
command once the
configuration is complete.
5. To check that the settings have been saved, turn the modem off
and power it on again.
6. Type
ati4
.
You should not see your own typing at this point,
but if you do, check your modem DIP switches and make sure
that the
ate0
command was issued successfully.
The new settings dump that is displayed should be identical to those
previously saved. If it is, your modem is now ready to be connected to
the AXIS 200!
at
OK
at&f
;load factory default settings
OK
at&b1
;lock DTE-DCE baud rate
OK
at&h2
;xon/xoff handshaking on
OK
atm0
;turn speaker off
OK
ate0
;command echo off
Note: this inhibits the display
of entered commands.
OK
at&w
;save settings to modem
OK
---------ready ----
To Next Page
Loading...
