Axis 200 - Page 85

AXIS 200 User’s Manual Appendix F: The RS232 Serial Port
83
Using FTP
1. Log in to the AXIS 200 with the command
ftp cameraname
where
cameraname
is the AXIS 200 host name or Internet
address
.
2. You will be prompted for user name and password. Use the user
id
root,
which has the default password
pass
.
3. Issue the command
get config
to copy the AXIS 200 config file
to a directory on your workstation
.
4. Log out using any of the commands
quit
,
bye
or
exit
depending on your FTP version.
5. Edit the AXIS 200 config file by setting the SERIAL_MODE
parameter to FULL_SUPPORT.
6. Start a new FTP session.
7. When you are logged in, issue the command
put config
download the edited file to the AXIS 200.
8. Log out again.
Dialing the server
You will reach the AXIS 200 modem server by dialing
ATDTnnnnnn,
where
nnnnnn
is the modem phone number, e.g.
ATDT555-1212
. The
AXIS 200 will then answer the call, and establish the connection.
Once the connection has been established, the AXIS 200 welcome
banner is displayed:
The Help menu
Type the following to view the help menu:
Welcome!
You are connected to the host shell of your AXIS
Camera Server.
Try 'help' for a list of available commands, or
just ‘sz fullsize.jpg’ to download an image.
$ he