Axis 200 - Page 93

AXIS 200 User’s Manual Appendix H: CRON Script Command Reference
91
Syntax
ftp [-host HOST] [-user USERNAME] [-pass PASSWORD]
[-src SOURCEFILE] [-dest DESTINATIONFILE]
[-temp TEMPORARY_DESTINATIONFILE] [-loop LOOPTIME]
[-time TOTALTIME];
Options
-host
Specifies the host name or the Internet address of the remote
host. If specifying the host name, performance is slightly
decreased due to the DNS lookup. If no host is specified, the
compiler will complain.
-user
The username used when logging on to the remote host. If no
username is specified, the compiler will complain.
-pass
The password used when logging on to the remote host.
-src
Specifies the source filename. If this parameter is omitted, the
fullsize.jpg
file will be sent. If an erroneous file name has
been specified, no action will be taken during execution.
-dest
Specifies the name and whole path of the destination file. If
this parameter is omitted, the destination file name will be the
same as the source filename. The maximum length of a
destination filename is 255 characters. You can add as many
destination files as required, separated by a space.
You can add time stamps, such as time, date and file indexes, to
the destination filename. This is useful for example when you
are transferring a series of files.
Note:
❏ The
rS-E
substitution can be used with the first destination file
only. To make sure all the files in a series are captured, you must
specify a sufficiently long execution time in the time attribute.