Page 6 AXIS 212 PTZ/-V Installation Guide
Connect the cables
1. Optionally connect external input/output devices, e.g. alarm devices. See page 13 for informa-
tion on the terminal connector pins.
2. Optionally connect an active speaker and/or external microphone.
3. Connect the camera to the network using a shielded network cable.
4. Connect power using one of the methods listed below:
• PoE (Power over Ethernet) via the network cable. This will automatically be detected if
available via the network.
• Connect the supplied indoor power adapter to the power connector on the camera unit.
5. Check that the network, status and power indicators (LEDs) light up green. See the table on
page 14 for LED descriptions.
To Next Page
Loading...
