3-
l Next
Go to next step of infrastructure type configuration. It is relative the security status of
selected access point.
n None: Setup TCP/IP.
n WEP: A WEP dialog is pope dup before Setup TCP/IP as below picture. You have to input the
password/network key to join this access point before setup TCP/IP. The password/network key is
defined by the administrator of access point. The invalid network key will stop going to next step.
l Cancel
Give up Wi-Set Wizard and keep the last configuration.
Setup TCP/IP
You have to setup the TCP/IP by
following the configuration of connect
access point. The following setting
should match the configuration of access
point you join. Please check the setting
of it.
l Back
Go back to previous step ~ Select the IBSS connection list
l Finish
All settings of infrastructure are finished.
3.3.2
Build Ad-Hoc networking mode network
It is easy to build up Ad-Hoc type network with Wi-Set Wizard. The next step after select
Ad-Hoc type network is to select the desired connection.
To Next Page
Loading...
Need help?
General
