3-
network connection this system provides. You have to pick one from the list.
l Back
Go back to previous step ~ Show Setting Information.
l Next
Go to next step, Finish, while the internet connection is selected.
If the status of selected network connection is disconnected, a warning dialog will pop up
to inform you that.
l Cancel
Give up current Wi-Set Wizard setup and roll back to previous configuration.
Finish
l Finish
Press finish button to close Wi-Set
wizard. The wireless configuration is
going to be applied within few seconds.
3.4.2 Advanced User
The steps of advanced user provide more detail configuration including channel and
authentication
Wireless Network Properties
In this step, you could assign the
channel number and authentication
mode for the access point.
If the setting of WEP to be “Disable” and
To Next Page
Loading...
