BL2 93317
Operating Manual 17
6.3.3 Adjusting the parameters with the remote control
Day operation (light evaluation inac-
tive) or Night operation
Open (unlock) the device – Activate
the programming mode
Select switch-on threshold or read in
current light value as new switch-on
threshold.
Follow-up time (illumination)
15 s – 60 min
Detection sensitivity Low (LOW),
Medium (MEDIUM)
or High (HIGH)
Status LEDs activated / deactivated
Close (lock) device
If no further input is made for
approx. 3 minutes, the programming
mode is automatically terminated.
To Next Page
Loading...
