B2 HVA28 - Page 59

Test Procedure
© b2 electronic GmbH DHV0086 Rev06 59
Step Procedure (Congureautotestsequence)
NS12: Test Purpose
Select one of the following test propose:
• Maintenance
• Acceptance
• Installation
NS13: U
0
Select this check box if you want to refer
to the voltage rating U
0
fordenitionofthe
test step voltage. Depending on the DUT
type, determine whether to use a
three-phase calculation or a one-phase
calculation of U
0
.
NS14: Next Step
Press “Next” to continue.