Baby Lock Solaris 2 User Manual (English)

Other manuals for Baby Lock Solaris 2

Questions and Answers:

B
Brandy FigueroaJul 26, 2025
Why bobbin thread does not wind neatly on my Baby Lock Solaris 2?
- C
  Corey KelleyJul 26, 2025
  If the bobbin thread isn't winding neatly on your Baby Lock Sewing Machine, it could be due to a few reasons. Make sure the thread is passed correctly through the bobbin winding thread guide. If the bobbin spins slowly, press in the bobbin winding window to increase the winding speed. Also, ensure the thread that was pulled out is wound around the bobbin 5 or 6 times clockwise, and that the empty bobbin is set properly on the pin until you hear it click.
T
Tim PerkinsJul 31, 2025
What to do if I cannot pull up the bobbin thread on my Baby Lock Sewing Machine?
- H
  holmesrebeccaJul 31, 2025
  If you're unable to pull up the bobbin thread on your Baby Lock Sewing Machine, the needle may be turned, bent, or dull, so replace it. Alternatively, the bobbin might be set incorrectly; in that case, reset the bobbin thread correctly.
K
Krista WhiteAug 5, 2025
What to do if the bobbin thread winds below the bobbin winder seat on my Baby Lock Solaris 2?
- R
  Roger BondAug 5, 2025
  If the bobbin thread winds below the bobbin winder seat while winding the bobbin on your Baby Lock Sewing Machine, it's likely that you didn't wind the bobbin thread properly initially, or the thread wasn't correctly set in the guides. Remove the thread wound below the bobbin winder seat, and then wind the bobbin correctly. Follow the images on the machine for guidance when threading for bobbin winding.
J
James JohnsonAug 9, 2025
What to do if nothing appears on my Baby Lock Sewing Machine LCD?
- M
  Michelle GonzalezAug 9, 2025
  If nothing is appearing on the LCD screen of your Baby Lock Sewing Machine, first, ensure that the main power switch is turned on. Also, verify that the power cord is properly inserted into an electrical outlet.
J
jonathon25Aug 14, 2025
What to do if the Baby Lock Solaris 2 screen has been locked?
- T
  Travis ThompsonAug 15, 2025
  If nothing happens when you press the LCD display on your Baby Lock Sewing Machine, the screen might be locked. Press either of the unlocking keys to unlock the screen.
J
jessicafoxAug 20, 2025
Why is my Baby Lock Solaris 2 LCD screen not clear?
- J
  Julia GomezAug 20, 2025
  If the LCD screen on your Baby Lock Sewing Machine doesn't look very clear, it might be that the screen brightness needs adjusting. Go to the settings screen and adjust the “Screen Display Brightness”.