Baby Lock Solaris 2 - Changing Thread Density (for Large Satin Only); Returning to the Beginning of the Stitch Pattern

EDITING STITCH PATTERNS
174
Changing Thread Density
(for Large Satin Only)
After selecting a satin stitch pattern, press , and
then press to select your preferred thread
density.
Returning to the Beginning of the
Stitch Pattern
When sewing character/decorative stitches, you
can return to the beginning of the stitch pattern
after trial sewing or when the stitching is sewn
incorrectly.
a
Press the “Start/Stop” button to stop the
machine, press , and then press .
 Sewing returns to the beginning of the selected stitch
pattern (“W”) from the point where sewing was
stopped.
b
Press the “Start/Stop” button to continue
sewing.
CAUTION
• If the stitches bunch when thread density is
changed to , return the thread density to
. If you continue sewing when the stitches
are bunched, the needle may bend or break.
Memo
• When the select all on/off key appears as
, the thread density of all stitch patterns
can be changed.
Memo
• If this key is pressed while sewing is
stopped, stitch patterns can be added at
the end of a combined stitch pattern. (In this
example, “!” is added.) Press or to
add the stitch pattern at the desired
location.