Baby Lock Solaris 2 - Stitch Settings; Setting the Stitch Width

STITCH SETTINGS
Sewing Basics
85
2
When you select a stitch, your machine automatically selects the appropriate stitch width, stitch length,
and upper thread tension. However, if needed, you can change any of the individual settings.
Setting the Stitch Width
Follow the steps below when you want to change
the zigzag stitch pattern width.
Example:
Press to narrow the zigzag stitch pattern
width.
 The value in the display gets smaller.
Press to widen the zigzag stitch pattern width.
 The value in the display gets bigger.
STITCH SETTINGS
Note
• Settings for some stitches cannot be changed (refer to “STITCH SETTING CHART” on page 210).
• If you turn off the machine or select another stitch without saving stitch setting changes (“Saving Your
Stitch Settings” on page 109), the stitch settings will return to their default settings.
Memo
• For an alternate method of changing the
stitch width using the speed controller, refer
to page 128.
Memo
• Press to save the stitch settings.
• Press to check changes made to the
stitch.
• Press to return the stitch width to
the original setting.
Note
• After adjusting the stitch width, slowly
rotate the handwheel toward you
(counterclockwise) and check that the
needle does not touch the presser foot. If
the needle hits the presser foot, the needle
may bend or break.