What to do if Baelz Automatic 373-E66 Controller linear actuator fails to move to the defined position?
If the Baelz Automatic Controller linear actuator fails to move or does not move correctly to the position defined by the input signal, the main board might be defective. If this is the case, replace the main board, and if necessary, remove the actuator and return it for repair.
What to do if Baelz Automatic 373-E66 linear actuator does not move to the end position?
If the Baelz Automatic Controller linear actuator does not move to the end position and the valve fails to open or close, it could be due to system pressure being too high; in that case, adjust the system pressure. It could also be caused by a poor input signal, interfering signals, or signal variations; in that case, check the input signal at the linear actuator and correct the problem causing the malfunction.
Why is the Baelz Automatic 373-E66 Controller actuator movement unsteady?
If the Baelz Automatic Controller actuator movement is unsteady, moving between OPEN and CLOSED, it could be due to power fluctuations exceeding the permissible tolerance; in that case, improve the power supply conditions. Alternatively, there may be a loose contact in the supply line; in that case, check and tighten connections (terminal strips).
What to do if Baelz Automatic 373-E66 linear actuator stops temporarily?
If the Baelz Automatic Controller linear actuator stops temporarily, it may be caused by a jammed valve. Ensure smooth valve movement to resolve this issue.
Why is my Baelz Automatic Controller actuator not operating?
If the Baelz Automatic Controller actuator won't operate, it could be due to several reasons. First, check for a power failure and correct it. If there is a defective fuse in the control cabinet, determine the cause, correct the problem, and replace the fuse. Ensure the linear actuator is correctly connected according to the circuit diagram. A short-circuit due to humidity may be the cause, in that case, determine the cause, dry the linear actuator, and replace the cover seal and screw joints, and/or attach a protective cover, as needed. If the short-circuit is due to an incorrect connection, connect it correctly. Motor winding damage or defective electronics could also be the issue; determine the cause, measure current data, compare it with the identification label and table, and return t...
General| Brand | Baelz Automatic |
|---|---|
| Model | 373-E66 Series |
| Category | Controller |
| Language | English |
To Next Page
