We recommend maintenance following an
extended shut down of the vehicle. Please
contact Dometic Customer Services.
Explanation of operating controls
Manual Energy selection/ automatic ignition
(RMD 8xx1) MES:
1. (Power on switch/ Energy selector switch
(MODE)
2. Temperature selection
3. Power On switch frame heating
4. Indicator LED failure
5. Indicator LED frame heating
6. Indicator-LED/ operating mode display
7. Temperature level display.
8. NOT APPLICABLE TO MODELS FITTED
TO BAILEY UNICORNS
9. External display “failure” (red)
10. External display “in operation” (blue)
Explanations
The refrigerator is equipped to operate on
mains power, 12V DC or liquid gas. Select the
desired power supply by turning the energy
selector switch (1)
The energy selector switch (1) has four
settings: • Off, • Mains voltage (230vAC), •
Direct-current voltage (battery, 12V DC), •Gas
(liquid gas propane/butane)
Switch the refrigerator ON or OFF by pressing
button (1) for 3 seconds. Button (1) allows you
to either initiate the requested energy supply
or activate dimming of the LED brightness. By
pushing once, the indicators illuminate for 10
seconds.
Button (3) allows you to switch on the
frame heating in order to avoid a rising of
condensation water due to high humidity.
During the frame heating operation the
indicator LED (5) is illuminating.
Electrical Operation
MES Appliances (manual energy selection)
To start the refrigerator, press button (1) for 3
seconds.
The LED (6) of the previously selected
operating mode illuminates:
230V Operation
12V operation
Gas operation
Changing the operating mode by pressing
button (1) again. The appropriate indicator
LED will illuminate.
MES- appliances
1. Press button (1) several times until the
indicator LED (6) illuminates.
2. The ignition process is activated
automatically by means of an automatic
igniter.
The ignition system will make 2 ignition
attempts with 25 seconds interval when
the burner fails to light. If repeated
attempts fail to start the operation, a
fault is indicated (please refer to failure
indication).
Setting of the cooling compartment
temperature
Select the desired cooling compartment
temperature by pressing button (2)
71
To Next Page
Loading...
