The LED display (7) of the selected temperature
setting is illuminated.
The scale starts with MIN position at the
bottom LED position (small crystal = highest
temperature) and climbs up to MAX position
at the upper LED position (largest crystal =
lowest temperature). Note: The temperature
levels do not relate to absolute temperature
values.
The cooling unit’s performance is inuenced
by ambient temperatures. Please select the
medium setting for ambient temperatures
between +15° and +25°. The unit operates
within its optimum performance range.
Dometic refrigerators work according to the
absorption principle. For physical reasons,
an absorption system responds slowly to
changes made by the thermostat controller,
by loss of cooling energy through opening the
door or during storing food. The devices meet
the cooling performance requirements of the
Climatic Class SN acc. To EN/ISO 7371 in the
temperature range of +10°C to 32° ambient
temperature.
For temperatures below +10°C, winter covers
should be installed. For ambient temperatures
exceeding +32°C for a longer period of time, it
is recommended installing Dometic additional
fan (item no. 241 2985 00).
Additional features (MES)
The brightness of the display reduces after a
few seconds if no other buttons are pressed.
If the door is open, the interior lighting is
switched off automatically after 2 minutes.
Failures are indicated by ashing of the failure
indicator LED.
Should the door be kept open for too long
(more than 2 minutes), the blue external LED
starts ashing until the door is closed.
Frame Heating
All models are equipped with a frame
heating (12VDC/3.5W) around the freezer
compartment. During summer months with
high temperatures and humidity the metal
frame may have water droplets forming. To
evaporate these droplets switch on the frame
heating with switch (3). The LED (5) indicates
that the heating is on.
The frame heating is in operation with a
presetting of 2 hours and switched off
afterwards automatically. The frame heating
can be deactivated every time by pressing the
button (3).
Door Locking
Manual door lock
Open the door by pressing the locking button
and pull open.
Shut the door again by pushing it to close. The
snapping into the lock can be heard.
While the vehicle is parked, the locking hook
may be xed to facilitate opening of the door.
Fastening and releasing the door lock hook
when parking the vehicle.
If the vehicle is parked for a longer time, the
locking hook may be clamped by means of a
lock bar. The door may now be opened by just
pulling it without need of pressing the locking
button.
As a basic rule, shut and lock the refrigerator
before you start your journey!
72
To Next Page
Loading...
