SOFT FURNISHINGS
SOFT FURNISHINGS
When cleaning the interior of your caravan
please remove the carpet from the vehicle.
Vacuum the carpets to take the dirt out of the
pile.
For general cleaning use a dry shampoo,
following the product’s directions.
Never put the carpet in a washing
machine or a tumble dryer.
UPHOLSTERY - CLEANING AND CARE
Remove dust on a regular basis with your
vacuum’s upholstery or drape attachment. Try
to avoid brushing fabric covers because that
can damage the pile.
If you spill something on your upholstery, blot
up the excess immediately. Avoid detergents
which may damage the fabric’s protection.
Use a sponge or a clean white cloth but do not
wash or rub the fabric. Leave to dry in normal
conditions. These actions will not affect the FR
(Fire Retardant) treatment of the fabric.
Heavy soiling will require professional
cleaning.
All fabrics will fade to some degree if exposed
to direct sunlight, particularly natural fibres
such as cotton etc.
WINTERISATION AND STORAGE
Mattresses are made from fire retardant
fabric and are of a honeycomb constriction
based on solid foam with diamond cut out to
perform like a spring. It is recommended that
mattresses be stored on edge during winter.
Try to keep your cushions away from direct
sunlight.
It is recommended that the curtains in your
caravan are washed on a delicate cycle at
30°C. This will not damage the clip glides.
Shrinkage may be caused should you decide to
dry clean your curtains.
Curtains should not be left closed during
daytime hours otherwise some fading may
occur.
REMIS BLINDS
REMIBASE PLUS WINDOW BLINDS
Please note the blinds should not be closed
(in the down position) when the vehicle is
travelling or when in storage for prolonged
periods.
The sun screen is housed at the bottom and
the fly screen at the top of the blind. To open
hold the cross bar and pull up or down. Both
blinds can be fully extended to totally cover the
window or can meet at any position to give sun
shading/privacy and protection from insects
entering the vehicle.
The blinds are pre-set to the correct tension.
If re-tensioning is required please follow these
steps:
• The blind needs to be taken down from the
wall by unscrewing the 4 corner screws.
• Lay the blind face down on a table with the
cross bars of both blinds meeting in the
middle.
• The black cords retension the fly screen and
the white cords retension the sun screen.
• The cords are fixed at either side with a
screw. Loosen this screw and gently pull the
cord 5mm tighter and repeat on the other
side ensuring the cross bar is level.
• Test the tension. This process can be
repeated if necessary.
The plastic profiles can be cleaned with a
non-abrasive cleaner and damp soft cloth. The
blinds should only be dusted lightly with a soft
cloth.
To Next Page
Loading...
