Why I cannot connect to the drive over TCP/IP on Baldor MotiFlex e100 Servo Drives?
If you cannot connect to the drive over TCP/IP, verify that there is no EPL manager node (e.g., NextMove e100 with node ID 240) on the network. If a manager node exists, an EPL-compatible router is required for TCP/IP communication on the EPL network. Also, ensure that the PC’s Ethernet adapter is correctly configured.
What to do if the Spy window does not update in Baldor Servo Drives?
If the Spy window does not update, the system refresh may be disabled. To fix this, go to the Tools, Options menu, select the System tab, and choose a System Refresh Rate (500 ms is recommended).
What does it mean if ETHERNET LEDs are blinking green and red simultaneously in Baldor Servo Drives?
If the ETHERNET LEDs are blinking green and red simultaneously, it might indicate that the MotiFlex e100 does not have firmware. This can happen if a firmware download failed. Try downloading new firmware to resolve this issue.
What to do if node has been successfully scanned but communication is still not possible on Baldor MotiFlex e100 Servo Drives?
For communication to be allowed, a connection must be made to a node after it has been scanned. Baldor controller nodes are automatically connected to after being scanned. Nodes that conform to DS401, DS403 must have the connections made manually using the Mint CONNECT keyword. If a connection attempt using CONNECT fails then it may be because the node being connected to does not support an object which needs to be accessed in order to setup the connection.
What to do if the Status LED is off on Baldor MotiFlex e100 Servo Drives?
If the Status LED is off, check that AC power (or shared DC bus supply) is present, or that the 24 VDC control circuit backup supply (if present) is connected correctly to connector X2 and is switched on.
General| Protection Class/Rating | IP20 |
|---|---|
| Humidity | 5% to 95% non-condensing |
| Dimensions | Varies by model |
| Weight | Varies by model |
| Control Type | Digital |
| Communication Protocols | Modbus TCP |
| Feedback Type | Resolver |
| Operating Temperature | 0°C to 40°C |
Provides critical safety warnings and essential precautions for operating the MotiFlex e100 equipment safely.
Covers the introduction, power sources, and hardware needed for basic installation.
Details the essential steps and considerations for physically mounting the MotiFlex e100.
Instructions for correctly connecting the AC power supply to the MotiFlex e100.
Explains the importance and methods for proper earthing/grounding of the MotiFlex e100.
Guides on how to connect the motor to the MotiFlex e100, including shielding.
Configuration and connection for the dedicated drive enable input.
Steps for connecting the MotiFlex e100 to a PC and installing Mint software.
Step-by-step guide to tuning the MotiFlex e100 and creating configuration.
Procedure for using the Autotune Wizard to optimize motor performance.
Adjusting tuning parameters for optimal response with and without load.
Steps for diagnosing problems and using the SupportMe feature for assistance.
Describes the meaning of the STATUS, CAN, and ETHERNET LEDs.
Troubleshooting steps for communication problems with USB, Ethernet, and CAN.
To Next Page
